Introduction to the specific maintenance method of powder packaging machine

Post: 2018-08-06

The specific maintenance method of powder packaging machine:


1、For lubrication work, it is necessary to regularly give its gear meshing parts, oil bearing holes with seat bearings and lubricating oil for each moving part. Once every shift, the speed reducer is strictly prohibited to run without oil. When filling the lubricating oil, be careful not to put the oil tank on the rotating belt to prevent damage caused by slipping or premature aging of the belt.


2、For cleaning work, after the equipment is shut down, the metering part should be cleaned in time. The heat seal body should be cleaned frequently to ensure the sealing line of the packaged product is clear. The scattered materials should be cleaned up in time to facilitate the cleanness of the parts and thus better. Extend the service life, and always clean the dust inside the electric control box to prevent electrical faults such as short circuit or poor contact.


3、Maintenance work, before using the powder packaging machine, it is necessary to check the screws of each part, there must be no looseness, otherwise, it will affect the normal long-distance of the whole machine, for the electrical parts should pay attention to waterproof, moisture-proof, anti-corrosion, anti-rat work. In order to ensure that the electrical control box and the terminal are clean to prevent electrical failure, after the shutdown, the two heat seal bodies should be in the open position to prevent the packaging material from being burnt.

© 2018 Tianjin Hondon Packaging & Food Machinery Co.,Ltd  All Rights Reserved.